54
GLOBAL
INDUSTRIES, INC.
Drag Conveyors
10230011
2016-06-14
TORQUE-ARM II BELT GUARD INSTALLATION
Assembly
Components
1)
Move the belt guard and hardware from the box and verify
all parts are available. The belt guard assembly consists of
one back cover, one front cover, (2) brackets, and necessary
hardware.
2)
Using the hardware provided, assemble the (2) brackets to
the back cover as shown in example a.
3)
Position the back cover over the motor shaft and reducer input
shaft. The long slot in the back cover fi ts over the motor shaft.
4)
Align the back cover assembly to the Torque Arm II motor
mount and attach using (4) cap screws, washers, and nuts.
Securely tighten the brackets to the motor mount and back
cover.
5)
Install the motor and reducer sheaves. Install the belts and
adjust accordingly.
6)
Align hinges on the front cover to pins on the back cover and
assemble.
7)
Close the cover and secure with (2) cap screws and washers.
8)
Check the machine for proper operation.
a) Mounting Brackets in Position B
WARNING!
To ensure the drive is not unexpectedly
started, turn off and lockout and tag
power source before proceeding. Remove
all external loads from the drive before
removing or servicing the drive or
accessories. Failure to observe these
precautions could result in bodily injury.
WARNING!
Make certain all guards are properly
installed before proceeding. Exercise
extreme care to avoid contact with
rotating parts. Failure to observe these
precautions could result in bodily injury.