York Fitness Diamond R301Plus, Owner'S Manual, Page: 10 / 20

22
8. Attach the pedals
1. Slide the pedal pivot rods through the main frame holes until
an equal amount of the rods protrude from each side.
2. Slide the spacers and pedal assemblies onto the pivot rods
from both ends and secure, using 4 x allen head bolts and
washers as shown
FIXINGS: FIXINGS:
x 4
Part
No.
47
9. Attach the computer
1. Remove the polyfoam block attached under-
neath the front end of the main frame.
2. Loosen the hand wheel knobs and rotate the
angle.
3.
plates in position.
4.
bracket and secure, using 4x machine screws
as shown. ( The machine screws are located in
the back of the computer console.)
5. Plug the computer wire into the socket on
bracket - make sure it’s fully connected.
x 4
Part
No.
35
x 4
Part
No.
33
shown in the diagram.
!
to the outside edge of the pedal for
easy adjustment of the strap.
!
FIXINGS: FIXINGS:
x 4
located in back
of console
Part
No.
22
Make sure the bolts are fully
tightened with two allen keys.
!
33
35
47
¶Â¦â
32
120
(black)
e m o r h c (
plate)
10