YOKOGAWA UM330, User Manual, Page: 28 / 50

2-8
<Toc> <2. Initial Settings>
IM 05F01D02-41E 1st Edition : May 31,2000-00
9.
Press the
S E T / E N T
key once to register the
setpoint.
P V
AL1 2 3 4
S E T / E N T
10.
Press the
S E T / E N T
key once to display the
parameter “UNIT” (PV input unit).
P V
AL1 2 3 4
S E T / E N T
Displays
parameter
“UNIT”.
11.
Press the
S E T / E N T
key once to display the
parameter “RH” (maximum value of PV
input range).
P V
AL1 2 3 4
S E T / E N T
Displays
parameter
“RH”.
12.
Press the or key to display the
required setpoint. The figure below shows
an example of setting the maximum value
of PV input range to 200.0
⬚
C.
P V
AL1 2 3 4
S E T / E N T
Blinks during
change.
13.
Press the
S E T / E N T
key once to register the
setpoint.
P V
AL1 2 3 4
S E T / E N T
14.
Press the
S E T / E N T
key once to display the
parameter “RL” (minimum value of PV
input range).
P V
AL1 2 3 4
S E T / E N T
Displays
parameter
“RL”.
15.
Press the or key to display the
required setpoint. The figure below shows
an example of setting the minimum value
of PV input range to 0.0
⬚
C.
P V
AL1 2 3 4
S E T / E N T
Blinks during
change.
16.
Press the
S E T / E N T
key once to register the
setpoint.
P V
AL1 2 3 4
S E T / E N T
17.
Press the
S E T / E N T
key for more than 3 sec-
onds.
This returns you to the display shown at
power-on (figure below).
P V
AL1 2 3 4
S E T / E N T
Displays PV.
* If the type of input is voltage, also config-
ure the PV Input Decimal Point Position
(SDP), Maximum Value of PV Input Scale
(SH), and Minimum Value of PV Input
Scale (SL) parameters that are displayed
after this.