YOKOGAWA UM330, User Manual, Page: 24 / 50

2-4
<Toc> <2. Initial Settings>
IM 05F01D02-41E
3.
Press the
S E T / E N T
key once to register the
setpoint.
P V
AL1 2 3 4
S E T / E N T
4.
Press the
S E T / E N T
key once to display the
parameter “UNIT” (PV input unit).
P V
AL1 2 3 4
S E T / E N T
Displays
parameter
“UNIT”.
5.
Press the S E T / E N T key once to display the
parameter “RH” (maximum value of PV
input range).
P V
AL1 2 3 4
S E T / E N T
Displays
parameter
“RH”.
6.
Press the or key to display the
required setpoint. The figure below shows
an example of setting the maximum value
of PV input range to 200.0
⬚
C.
P V
AL1 2 3 4
S E T / E N T
Blinks during
change.
7.
Press the
S E T / E N T
key once to register the
setpoint.
P V
AL1 2 3 4
S E T / E N T
1st Edition : May 31,2000-00
8.
Press the
S E T / E N T
key once to display the
parameter “RL” (minimum value of PV
input range).
P V
AL1 2 3 4
S E T / E N T
Displays
parameter
“RL”.
9.
Press the or key to display the
required setpoint. The figure below shows
an example of setting the minimum value
of PV input range to 0.0
⬚
C.
P V
AL1 2 3 4
S E T / E N T
Blinks during
change.
10.
Press the
S E T / E N T
key once to register the
setpoint.
P V
AL1 2 3 4
S E T / E N T
If the type of input is voltage, also config-
ure the PV Input Decimal Point Position
(SDP), Maximum Value of PV Input Scale
(SH), and Minimum Value of PV Input Scale
(SL) parameters that are displayed after
this.
11.
Press the S E T / E N T key for more than 3 sec-
onds. This returns you to the display
shown at power-on (figure below).
P V
AL1 2 3 4
S E T / E N T
Displays PV.
The PV display in the figure above shows
the error code for input burnout (
) if
PV input wiring is not yet complete. The
error code disappears when you wire the
PV input terminals correctly.