<2. WIRING AND INSTALLATION>
2-3
IM 12A01F01-02EN 2nd Edition : Feb. 19, 2019-00
2.3
Removing the shield cover
The shield cover covers high-voltage power supply terminals and relay modules.
CAUTION
To ensure your safety, be sure to shut down the power supply before you remove the shield
cover.
Open the front panel and remove the shield cover. After removing the shield cover, install the
cable glands.
To remove the shield cover, loosen the 2 screws at Δ (triangle). Pull out the shield cover by
holding the marked point :○ (circle) (Figure 2.2).
NOTE
Be careful not to lose the shield cover screws.
shield cover
DO NOT REMOVE
these screws.
screws
Figure 2.2
Shield cover
Summary of Contents for FLXA402
Page 7: ...Blank Page...
