IM 01C22K01-01E
3-1
3. COMPONENT NAMES
3.
COMPONENT NAMES
F0301.EPS
Vertical impulse piping type
Pressure-detector section
Cover flange
Process connection
Process
connection
Process connector
Process connector
External indicator
conduit connection(Note 1)
Horizontal impulse piping type
Terminal box cover
Conduit
connection
Conduit
connection
Zero-
adjustment
screw
Vent plug
Drain plug
Integral indicator
(Note 1)
CPU
assembly
Mounting
screw
Amplifier cover
Pressure-detector
section
Transmitter section
Manifold
Range-setting switch
(Note 1)
(See Subsection 7.7)
Setting pin(CN4)
Setting Pin (CN4)
Position
(Note 2)
Burn-Out
Direction
Output at
Burn-Out
H
L
H
L
HIGH
LOW
110% or
higher
-5% or
lower
(Note3)
Note 1: See Subsection 10.2, “Model and Suffix Codes,” for details.
Note 2: Insert the pin (CN4) as shown in the figure above to set the burn-out direction. The pin is set to the H side for delivery (unless
option code /C1 is specified in the order).
The setting can be confirmed by calling up parameter D52 using the BRAIN TERMINAL. Refer to Subsection 8.3.3 (10).
Note 3: If optional code /F1 is specified, output signal is –2.5% or lower.
Figure 3.1 Component Names
Table 3.1 Display Symbol
Display Symbol
%, Pa, kPa, MPa, kgf/cm
2
, gf/cm
2
, mbar, bar, atm,
mmHg, mmH
2
O, inH
2
O, inHg, ftH
2
O, psi, Torr
Meaning of Display Symbol
Display mode is ‘square root’. (Display is not lit when ‘proportional’ mode.)
The output signal being zero-adjusted is increasing.
The output signal being zero-adjusted is decreasing.
Select one of these sixteen available engineering units for the display.
T0301.EPS
