Yokis Thermarp, Installation, Programming And Use Instruction Manual

Page: 30 / 40

DS1054-057
P0
10.4.3. How to extend the range
All YOKIS wireless receivers also serve as signal repeaters. By adding one or more modules, you can significantly
extend the wireless range by creating a wireless bus between the various modules on the system.
1) Create the wireless bus
Press
the
Connect button on module A once
(the LED on module A will start flashing), then
press
the
Connect
button on module B once
(the connection between A and B is established and the 2 modules stop flashing).
The two presses must occur
within a maximum time of 30 seconds
.
Led
Connect
Led
Connect Led
Connect
A
B C
1 press 1 press
ETC
.
Repeat the same operation on modules B and C and so on, for all the others.
2) Pair the THERMARP thermostat with the module that controls the boiler
After creating the wireless bus, temporarily move the thermostat to near the module that controls the boiler. Pair
the THERMARP thermostat with the module that controls the boiler, following the steps described above.
3) Set the access point on the wireless bus
Place the thermostat in its final position.
Return to the Wireless menu
of the THERMARP thermostat.
Use the buttons and to navigate the configuration menu to the AP E7 “Bus Access Point” submenu,
then tap the “Confirm” icon .
▶
▶
▶
▶
▶
▶
Note:
The THERMARP thermostat may not be able to communicate
with the receiver if it is out of range. The message Err. 17 will
appear on the display in this case. See the “How to extend the
range” paragraph.
Once the mode has been validated, the message
AP E7
starts flashing to confirm that the THERMARP thermostat
is in “Bus access point” pairing mode. Press the “Connect”
button of the module closest to the THERMARP thermostat
once to establish the connection. The PASS message
appears briefly to confirm the connection.
▶
Led
Connect