DS1054-057
P10
7.1. TIME AND DATE
Proceed as follows to change the set time and date:
On the operating screen, hold button
pressed for three seconds. The icon
will start flashing on the
display.
Press button
to access the parameter configuration. The icon
will stop flashing.
The seconds field will start flashing.
Use buttons
and
to change the values. Press button
to confirm and move on to the next
parameter.
The parameter sequence to be entered is:
seconds* -> minutes -> hours -> year -> month -> day
.
(*) For seconds, only resetting to 00 is possible by pressing the buttons
and
.
Once all the parameters have been set, to exit and return to the configuration menu, briefly press the button
. The icon
will start flashing again. To exit and return to normal operation (automatic, manual), hold
button
pressed or wait for the timeout (approx. 40 seconds).
Note:
this menu can also be used to change the parameters for the standard/daylight saving time switch, as
described below.
7.1.1. Changing the daylight saving time settings
By default, the thermostat is configured to switch to daylight saving time on the last Sunday in March at 02:00
a.m. and to switch back to standard time on the last Sunday in October at 03:00 a.m. as customary in Europe.
Therefore, no changes are normally necessary.
It is however possible, in the case of particular installations, to disable the automatic time switch or to change the
date or time of the time switch.
Proceed as follows in this case:
1.
2.
4.
5.
When changing any of the parameters (seconds, minutes,
hour, year, month or day), hold button
pressed until
“Aut0” appears on the display.
Use buttons
and
to choose whether to keep the
automatic time change (Aut0 0n) or deactivate it (Aut0
0FF) and confirm with button
.
Setting 0FF will go back to time/date change. By setting
0n the daylight saving time switch setting (marked by the
symbol
) is displayed. In the example:
a. Sunday (7) of the last week (LA) of March (03) at 2 a.m.
(02)
b. If necessary, change the parameters using buttons
and
, move on to the next parameter using the
button
. The sequence requires entering:
i.
day (1...7) of the week
ii.
week of the month (first, second, third,
fourth, last - LA)
iii. month (1…12)
iv. time
1.
2.
3.
3s
If OFF
If ON
NEXT PAGE
Summary of Contents for Thermarp
Page 38: ...DS1054 057 P38...
Page 39: ...P39 DS1054 057...
