RADIO: Connected dimmer for light
control
DS1054-076
P9
GB
Technical specifications
-
Mains voltage:
230 V ~ (+10% -15%) - 50Hz
-
Minimum power:
5 W
-
Maximum power:
150 W 0,6 A
-
Radio frequency band:
2400 - 2480 MHz
-
Maximum radio power transmitted: 10mW
-
Ambient temperature:
from -20°C to +40°C
-
Relative humidity:
from 0 to 90%
-
Dimming:
on sinusoidal at start or end of phase with automatic
load type detection
-
Protections:
short-circuit and overheating protections
-
Degree of protection:
IP30
-
Dimensions of buttons (W x H):
22,5 x 45 mm
-
Dimensions of module (L x H x D): 22,5 x 50 x 50,5 mm
Functions
The module allows you to adjust the light intensity of:
LED lamps, fluorescent lamps, halogen lamps, incandescent lamps,
dimmable electronic transformers for incandescent lamps and transformers
ferromagnetic for incandescent or LED lamps.
This module can be controlled:
- from the button on the device;
- by one or more additional local buttons;
- via radio from remote control;
- remotely via the YnO app.
It is also possible to carry out centralization via radio using the module
cod. 5454815 or via a remote control.
MTV150EBRP
5454813
Connected dimmer for light control, 1 module
RADIO RANGE:
POWER range:
• inside 100 m² apartments with
perpendicular crossing of main wall
or ceiling
• 250m in open range
(Note: in both cases the range may
be reduced by presence of metallic
elements, crossing of walls or parti-
tions).
RADIO TRANSMISSION
The transmitter LED will light up
only if radio
transmission was successful.
Adding an intermediate receiver
makes it possible to solve a problem
of insufficient range.
Refer to the transmitter instruction
booklet for more information.
WIRING
Installing Cautions
The module must be installed only by qualified personnel and into a place the end-user cannot access, according
to the installing national rules. In order to follow the safety rules, the module must be connected to a power line
that is upstream protected by a magnetothermic switch 10A C curve.
With the low voltage light bulbs do not mix the ferromagnetic, electronic and toroidal transformers.
DO NOT INSTALL ON REMOTE CONTROLLED SOCKETS - Installation on remote controlled sockets is risky because
end users could connect any type of electrical load and damage the module as a consequence.
CAUTION
Accessory FDVDT (Code
5454075) must be installed
if the power line of the
module is shared with
inductive loads
(e.g. window
shutters or ferromagnetic
ballasts or ferromagnetic
transformers). The accessory
must be connected as close
as possible to the module in
parallel between live and
neutral.
The
internal
overvoltage protection of the
module could be rapidly
damaged
without
this
accessory. The module must
be installed according to the
rules in force in the country in
which it is sold.
Optional
pushbuttons
5454815
Optional
5454813
Centralised
RADIO control
Specific
RADIO control
2
30V ~
max
150 W
P1
P2
L
N
L
N
E5
R1
E5
N
L
BP
L
N
E5
Optional
Remote control
Optional
Remote control
