YILMAZ PCC 6505, Manual

Page: 45 / 87

45
7.6.4 Calibration of 45 Degrees

Enter 45 in section and press on send button.

Place 45 degrees calibration apparatus between miter and saw as shown in below figure.

If angle is bigger than 45 degrees, enter a smaller value to target section and press on send button.

If angle is smaller than 45 degrees, enter a bigger value to target section.

When 45 degrees is achieved, press on button to confirm the process.
7.6.5 Calibration of 90 Degrees:

r 90 in section and press on send button.

Place 90 degrees calibration apparatus between miter and saw as shown in below figure

If angle is bigger than 90 degrees, enter a smaller value than 90 degrees to target section and press on send button. If it is
smaller than 90 degrees, enter a bigger value than 90 degrees to target section.