Short Form Installation Guide
Introduction
8
CAUTION
Receiving
#
Use the specified combination of servomotor and XtraDrive.
Failure to observe this caution could result in fire or equipment
failure.
Reference
Page No.
11
Installation
#
Never use the equipment near flammable materials or where it
may be exposed to splashes of water or corrosive or flammable
gases.
Failure to observe this caution could result in electric shock or fire.
13
Wiring
#
Do not connect three-phase power supply to XtraDrive output
terminals U, V, and W.
Failure to observe this caution could result in personal injury or
fire.
#
Securely tighten screws on the terminal block and ground
terminals of power input and motor connections.
#
When using a 400V XtraDrive, the amount of current leaking from
the power line increases. Therefore, use cables and isolation
materials rated for 400V, and keep the wires as short as possible.
17
17
17
Operation
#
To avoid accidents, perform a test run of the servomotor with no
load.
Failure to observe this caution could result in personal injury.
#
Before starting operation with a load connected, set up user
constants suitable for the machine.
Failure to do so could result in overrun failure. When the load
moves vertically, incorrect setting of the user constants may cause
the load to fall.
#
Before starting operation with a load connected, make sure
emergency-stop procedures are in place.
Failure to observe this caution could result in personal injury.
#
During operation, do not touch the XtraDrive's heat sink.
Failure to observe this caution could result in burns.
#
Motor overload protection is internally provided. For further
information, refer to the XtraDrive User Manual Cat. No. 8U0108.
30
30
30
30
31
Inspection and Maintenance
#
Never change wiring while power is ON.
Failure to observe this warning could result in electric shock or
personal injury.
31
Summary of Contents for XtraDrive XD Series
Page 2: ...Short Form Installation Guide Introduction 2...
Page 9: ...Short Form Installation Guide Introduction 9 1 2 Warning Label...
Page 24: ...Short Form Installation Guide Wiring 24 4 2 5 Three phase 200V Main Circuit...
Page 26: ...Short Form Installation Guide Wiring 26 4 2 7 Three phase 400V Main Circuit...