Yenista Optics TUNICS T100S-HP, User Manual

Page: 13 / 66

Product Presentation
TUNICS T100S-HP User Manual 13
Table 3: Technical Specifications
Environmental Specifications
Low frequency modulation
DC to 8 MHz (sinusoidal), DC to 1 MHz (TTL)
High frequency modulation
30 kHz to 200 MHz
Output fiber type
SMF or PMF (option)
Output connector
FC/APC
Communication interfaces
*8 RS-232C and GPIB (IEEE-488.1)
Temperature / Humidity range +15 °C to +30 °C (+60 °F to +85 °F) / <80% (non-condensing)
Power supply 100 to 240 V a.c. / 50 to 60 Hz / 60 W
Fuse Type
4.0 A 250 V SLOW/(T)
Laser safety classification Class 1M (IEC 60825-1:2007 standard)
Laser type External cavity laser diode
Laser output
Single mode optical fiber
Laser Output divergence
(full angle at 1/e2)
0.18 rad
Dimensions (W x H x D)
448 x 370 x 133 mm
Weight 12.5 kg
All specifications are given after 60 minutes warm-up and apply for wavelengths not equal to any absorption line.
*1: Measured over a 0.1 nm bandwidth ±1 nm from the signal.
*2: For output power ≥ 0 dBm.
*3: Over one hour at constant temperature.
*4: Measured at 100 MHz.
*5: O and CL at 10 dBm / Others at 8 dBm, ±40 pm all at 0 dBm.
*6: Validated at 0 and +10 dBm for essential and 0 and +8 dBm for extended range models.
*7: Over 100 wavelength scans at constant temperature.
*8: GPIB tested & validated with National Instruments GPIB Board.
Essential Models Extended Range Models
O CL O+ ES SCL CLU
Equipment Type Test and Measurement
Safety Class Basic insulation, as defined in IEC-61010-1. Grounded product.
Mains supply voltage 100–240 V AC with

10% fluctuation max.
Installation
(over-voltage)
category
Over-voltage category II, as defined in
IEC 61010-1.
Local-level mains (wall sockets). Equipment at this level includes
appliances, portable tools, and similar products. Equipment is
usually cord-connected.
Pollution Degree Pollution Degree 2, as defined in IEC 61010-1.
Rated for indoor use only.
Normally only dry, non-conductive pollution occurs. Occasional
and temporary conductivity caused by condensation may
occur. This location is a typical office/home environment.
Temporary condensation occurs only when the product is left
unused.
Safe operating
temperature range
+10 ˚ C to +35 °C (+50 ˚ F to +95 °F)