yellow jacket TQ12007, Owner'S Manual

Page: 7 / 30

7
TO ADD JACK OIL
TO REPLACE JACK OIL
1. Position the jack on level ground and lower the
saddle.
2. Remove the oil plug.
3. Fill the oil case until oil level is just beneath the
lower rim of the oil fill hole.
4. Replace oil plug.
5. Perform the System Air Purge Procedure.
1. Position the jack on level ground and lower the
saddle.
2. Open release valve by turning handle counter-
clockwise (4 full turns).
3. Remove the oil fill plug.
4. Turn the jack on its side so that old oil will drain
from the oil fill hole.
• DO NOT USE MOTOR OIL IN THE JACK.
• ONLY USE ANTI-FOAMING JACK OIL.
• ALWAYS USE A GOOD GRADE HYDRAULIC
JACK OIL.
• DO NOT USE HYDRAULIC BRAKE FLUID,
ALCOHOL, GLYCERINE, DETERGENT, MOTOR
OIL OR DIRTY OIL.
• USE OF A NON-RECOMMENDED FLUID CAN
CAUSE DAMAGE TO A JACK.
• AVOID MIXING DIFFERENT TYPES OF FLUID
AND NEVER USE BRAKE FLUID, TURBINE
OIL, TRANSMISSION FLUID, MOTOR OIL OR
GLYCERIN. IMPROPER FLUID CAN CAUSE
PREMATURE FAILURE OF THE JACK AND THE
POTENTIAL FOR SUDDEN AND IMMEDIATE
LOSS OF LOAD.
• D I S P O S E O F H Y D R A U L I C F L U I D I N
ACCORDANCE WITH LOCAL REGULATIONS.
Additional Bottle Jack Notes:
• Periodically check the pump piston and ram for
signs of rust or corrosion. Clean as needed and
wipe with an oil cloth. NEVER USE SANDPAPER
O R A B R A S I V E M AT E R I A L O N T H E S E
SURFACES!
• When not in use, store the jack with pump piston
and ram fully retracted.
ADDITIONAL WARNINGS:
5. Position the jack on level ground and lower the
saddle.
6. Fill the oil case until oil level is just beneath the
lower rim.
KEEP DIRT AND OTHER MATERIAL CLEAR
WHEN POURING.
7. Replace oil plug.
8. Perform the System Air Purge Procedure.