User Guide for the CP860 IP Conference Phone
76
2.
Press the Conf soft key to place a new call.
The active call is placed on hold.
3.
Enter the number of the second party and press , , or the Send soft
key.
4.
When the second party answers the call, press the Conf soft key to add the second
party to the conference.
5.
Press the Conf soft key to place a new call.
The conference is placed on hold.
6.
Enter the number of the new party and then press , , or the Send soft
key.
7.
When the new party answers the call, press the Conf soft key to add the new party
to the conference.
8.
Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call on specific servers may be different
from that introduced above. Contact your system administrator for more information.
You can use call pickup to answer someone else’s incoming call on your phone. The
CP860 IP conference phone supports directed call pickup and group call pickup.
Directed call pickup is used for picking up a call that is ringing at a target phone number.
Group call pickup is used for picking up a call that is ringing at any phone number in a
certain group. The pickup group should be predefined, contact your system
administrator for more information.
You can pick up an incoming call by using the DPickup/GPickup soft key. To use call
pickup, you need to configure the call pickup code beforehand via web user interface.
Note
Directed Call Pickup
To enable directed call pickup and configure the directed call pickup code via web user
interface:
1.
Click on Features->Call Pickup.
2.
Select Enabled from the pull-down list of Directed Call Pickup.
If there are many incoming calls at the same time, pressing the GPickup soft key on the
phone will pick up the call that rings first.
