EtherAnt II User’s Manual
Figure 2.1 shows the antenna in a typical
horizontally polarized installation. It must be
carefully aimed at the base antenna and be
mounted with the same polarization. The
housing is sealed to prevent water build-up in
the antenna. The round connector must also
be sealed after it is plugged into the antenna.
Be sure to provide strain relief for the Ethernet
cable as well.
If this EtherAnt II antenna is aimed at a
vertically polarized omni-directional or sector
base station antenna, it must be mounted
vertically polarized using the other mounting
stud on the back.
Figure 2.1. – Outdoor Pole Mount Installation
Figure 2.2 shows the antenna in a typical
indoor wall mount installation. For indoor
applications, the range will depend on the
walls and other obstacles between the
EtherAnt II and the base station. The only way
to accurately determine your coverage area is
to put up the EtherAnt II in the best locations
available and run some tests.
Figure 2.2 – Indoor Wall Mount Installation
Version 3.3
Page 5
March 2003
Summary of Contents for EtherAnt II
Page 1: ...Version 3 3 March 2003 ...
Page 27: ...EtherAnt II User s Manual Version 3 3 Page 24 March 2003 ...
Page 28: ......
