31
|
eSC S1-X
–
User manual
PRE-RUN CHECKS
Based on the experience gained during the many track tests done, the preliminary checks to be done before a run are
indicated below:
•
Check if the brake hydraulic system has leaks or air bubbles that cause longer lever movement without brake
pressure
•
Check that the brake discs are not bent due to the excessive heat generated during hard braking or after a crash
•
Check the condition of the brake pads
•
Check the tire pressure. See Technical Regulations for cold and hot values.
•
Check that the battery voltage is higher than 52V
•
Check that the battery temperature is below 40 °C (Maximum allowed temperature = 65 °C)
•
Check that the motor temperature is below 45 °C (Maximum allowed temperature = 135 °C)
Check that the inverter temperature is below 35 °C (Maximum allowed temperature = 90 °C)
Image 17
–
Battery position
17.
How to Start the Scooter
Dash
Battery Step
Positive Poles
Negative Pole
Signal connector /
Yellow Plastic Cap
Summary of Contents for eSC S1-X
