YATO YT-82460, Manual, Page: 9 / 52

9 ORIGINAL INSTRUCTIONS
GB
or socket in any manner to make them fi t. The device must be
connected directly to a single supply network socket. It is forbid-
den to use extension cords, adapters, or double sockets. The
supply network circuit must be equipped with a 16 A protection.
Avoid contact between the power cord and sharp edges and hot
objects and surfaces. During operation, the power cord must al-
ways be fully extended, and the position of the power cord must
be set so that it does not become an obstacle during operation.
The power cord should not be placed in a manner that would
pose a risk of tripping. The supply socket should be located in
a place where it is always possible to remove the device power
cord plug quickly. Always pull the power cord by the plug hous-
ing when unplugging it, never by the cord. If the power cord or
the plug is damaged, immediately disconnect it from the supply
network and contact an authorised service centre of the manu-
facturer for replacement. Do not use the product with a damaged
power cord or plug. The power cord or plug cannot be repaired
and must be replaced with a new one that is free of defects if
these components are damaged.
WARNING! The metal components of the tool can be hot dur-
ing and immediately after use. Do not touch them, as it may
cause severe burns. Allow the device components to cool down.
Use gloves that protect against high temperatures if you need
to move these components before they cool down. Make sure
that the fl oor near the place of use of the device is not slippery.
This will prevent slipping, which can cause serious injuries. Never
block or restrict the fl ow capacity of the air inlet openings. Never
point the device at people or animals. Do not check the blowing
temperature by directing the air stream towards any part of the
body. Never use the device as a hair dryer. Do not use the device
in the bathroom or near water. Do not touch the nozzle or tip end,
as this may cause burns. After use, allow the tool to cool down
before storing it. Do not accelerate the process of self-cooling of
the device components in any manner.
OPERATING THE APPLIANCE
Installation of accessories
CAUTION! Only install the equipment when the supply voltage is disconnected. Pull the tool
power cord plug out of the power socket!
Before assembly and disassembly of the device, make sure that all components have
cooled down.
Before starting assembly, make sure that the soldering station power switch is in the o ff
position – O.
Slide the soldering iron base into the slot in the station housing. Place the soldering iron
on the stand.
Position the station at the workplace, e.g., on the table to ensure easy access to the con-
trols and that any object does not cover the display reading. Place the soldering iron stand
near the station to ensure free access to the soldering iron and prevent the soldering iron
tip from unintentional coming into contact with any object during operation, storage on the
stand, and movement of the soldering iron during operation. Due to the high temperature of
the tip, leave at least 10 cm of free space around the stand. The station should be placed
on a heat-resistant surface.
Only after setting up the station and a test for proper operation can the station be connected
to the power supply.
Operating the appliance
Switch the device on by moving the power switch to the on position – I.
The temperature of the tip is controlled with the knob and its setting is shown on the display.
The display also shows the operating status of the station after the temperature indication.