16
YASKAWA
SIEP C730600 0MA BACnet/IP Technical Manual
3.
Use the two screws included in the option kit to fasten the option card to the metal standoffs on the bypass
PCB. Use a short-shaft, magnetic screwdriver for narrow enclosure models H6BPxxxx. Tighten each
screw to 0.5 to 0.6 N•m (4.4 to 5.3 in lbs).
Figure 5.6 Insert Option into Bypass PCB CN5 Connector Port
4.
Firmly insert the end of the customer-supplied network cable into the CN1 connection port on the option
board. When you have a dual-port option, connect two network cables to the two network ports in CN1 for
flexibility in cabling topology.
Figure 5.7 Connect Network Cable to Option
NOTICE
Separate the communication wiring from the input power wiring and the motor wiring. Electrical
interference can cause communication data errors.
5.
Make sure that you did not pinch cables between the front cover and the bypass enclosure, then replace
and secure the front cover.
6.
Set drive parameters in
Related Drive Parameters on page 18
for correct option performance.
CN5
