2.7 Removing/Reattaching Covers
YASKAWA
TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup
33
■
Remove the Front Cover
1.
Remove the bypass front cover in Procedure A
2.
Loosen the front cover screw.
Figure 2.10 Loosen the Front Cover Screw
3.
Push on the tabs in the sides of the front cover then pull the front cover forward to remove it from the drive.
Figure 2.11 Remove the Front Cover
■
Reattach the Front Cover
1.
Wire the drive and other peripheral devices.
2.
Reverse the steps to reattach the cover.
Note:
• Make sure that you did not pinch wires or signal lines between the front cover and the drive before you reattach the cover.
• Make sure that the tabs on the sides of the front cover correctly click into the hook.
• Tighten the screws to a tightening torque of 0.98 N
∙
m to 1.33 N
∙
m (8.67 in
∙
lb to 11.77 in
∙
lb).
Figure 2.12 Reattach the Front Cover
