4.3
The Drive and Programming Modes
The drive functions are divided into two main groups accessible via the Digital LED Operator:
Drive Mode:
The Drive mode allows motor operation and parameter monitoring. Parameter
settings cannot be changed when accessing functions in the Drive Mode
)
.
Programming Mode:
The Programming Mode allows access to setup/adjust, verify
parameters. The drive prohibits changes in motor operation such as start/stop when the Digital
LED Operator is accessing a function in the Programming Mode.
illustrates the different functions visible as the “Up arrow” is scrolled immediately
after powering up the drive.
Note:
When b1-08 (Run Command Selection while in Programming Mode) is set to 1 (enabled), the drive can
run even if the mode is switched to the programming mode. When setting b1-08 to 0 (disabled), the mode
cannot be switched to the programming mode while the drive is running.
Table 4.3 Summary of Modes
Mode Group
Description
Key Press LED Digital Operator Display
Drive Mode Functions
(Motor operation and
monitoring)
Frequency Reference Display
(Initial power-up state)
STOP
Forward/Reverse
STOP
Output Frequency Display
STOP
Output Current Display
STOP
Output Voltage Reference
STOP
Monitor Display
STOP
Programming Mode Functions
(Changing parameters)
Verify Function
STOP
Setup Group Parameters
STOP
All Parameters
STOP
<1>
The enlarged illustration of the LED indicates that the LED is on.
4.3 The Drive and Programming Modes
YASKAWA ELECTRIC TOEP C710606 25D YASKAWA AC Drive J1000 Installation & Start-Up Manual
85
4
Start-Up Programming & Operation
