Table 4.1 Keys and Displays on the LED Operator
No.
Display
Name
Function
1
Data Display Area
Displays the frequency reference, parameter number, etc.
2
ESC Key
Returns to the previous menu.
3
RESET Key
Moves the cursor to the right.
Resets the drive to clear a fault situation.
4
RUN Key
Starts the drive.
5
Up Arrow Key
Scrolls up to select parameter numbers, setting values, etc.
6
Down Arrow Key
Scrolls down to select parameter numbers, setting values, etc.
7
STOP
STOP Key
Stops the drive.
Note:
Stop priority circuit. Pressing the STOP key will always
cause the drive to stop the motor, even if a Run command is
active at any external Run command source. Set parameter o2-06
to 0 to disable the STOP key priority.
8
ENTER Key
Selects all modes, parameters, settings, etc.
Selects a menu item to move from one display screen to the next.
9
LO/RE Selection Key
Switches drive control between the operator (LOCAL) and the
control circuit terminals (REMOTE).
Note:
LOCAL/REMOTE key effective during stop in drive
mode.
10
RUN Light
Lit while the drive is operating the motor.
11
LO/RE Light
Lit while the operator (LOCAL) is selected to run the drive.
12
ALM LED Light
Refer to LED Screen Displays on page 81
.
13
REV LED Light
14
DRV LED Light
15
FOUT LED Light
4.2 Using the Digital LED Operator
80
YASKAWA ELECTRIC TOEP C710606 25D YASKAWA AC Drive J1000 Installation & Start-Up Manual
