M8 × 35
× 2
4
Figure 4a
Figure 4c
Figure 4d
Figure 4b
6. Connect the chute lock cable to the lock latch by fitting the
cable ball end into the slot on the lock latch and then insert
the chute lock cable fitting into the bracket on the chute
pedestal. (See
Figure 4d, Illustration 2 & 3
)
7. Adjust and tighten jam nuts on cable fitting to remove cable
slack. be sure not to pretension lock latch so it retracts from
the gear teeth. (See
Figure 4d, Illustration 4
)
8. Release the lock latch on the gear assembly and turn the
discharge chute straight ahead.
9. To ensure the discharge chute and chute deflector follow
their full range of travels, make sure the joystick is in the
center position. (See
Figure 4d
)
5. Remove the gear cover by removing the two ST4.8×13 self-
tapping screws. (See
Figure 4c
)
1
2
M8×20
(×2)
Jam Nut
Cable Bracket
3
If the above adjustment does not create enough cable
tension, follow the steps below:
a. Loosen the jam nut by turning it counter clockwise with
10 mm wrench. (see
Figure 4b
,
Illustration 1
)
b. Tighten or loosen the cable by turning the cable
adjustment nut clockwise or counter clockwise with
10 mm wrench until you have reached your required
tightness. (see
Figure 4b
,
Illustration 2
)
c. Once tightness is set, return the jam nut against the handle
to hold the cable in place. (see
Figure 4b
,
Illustration 3
)
ST4.8×13
(×2)
1
2
3
Adjustment
Nut
Jam Nut
Jam Nut
2
4
3
1
10
mm
13
mm
18
mm
16
mm
30
mm
32
mm
10
mm
13
mm
18
mm
16
mm
30
mm
32
mm
× 2
10
mm
13
mm
18
mm
16
mm
30
mm
32
mm
× 2
10
Two-Stage Snow blower
»
Operator’s Manual
YB6870PM00 - 1807
Assembly
|
