Yanmar ZT350 series, Installation Manual

Page: 37 / 80

INSTALLING ENGINE AND DRIVE UNIT
ZT350 Installation Manual 4-15
Installing the Transom Assembly
12/05
© 2007 Yanmar Marine International
Installing the Steering System
Note: For dual installations the power steering
unit can be mounted on the port or
starboard transom assembly. Measure
the exact distance between stern-drive
centerlines. Use a proper tie bar
(See
Internal and External Tie Bar on
page 2-5)
.
1. Inspect the bushings for debris.
2. Lubricate the power steering bushings.
Figure 4-28
Figure 4-28
1 – Power Steering Bushings
3. Remove the upper and lower pivot bolts and
lubricate the threads liberally.
Figure 4-29
Figure 4-29
1 – Lock Tab Washers
2 – Upper and Lower Pivot Bolt
4. Position the steering assembly so that the pivot
bolts will fit in the bushings in the power
steering cylinder.
5. Install the upper and lower pivot bolts along with
the lock tab washers. Ensure that the lock tab
washer tangs straddle the ridge on the inner
transom plate.
Upper Pivot Bolt and Tab Washer Shown (Lower
Similar)
Figure 4-30
Figure 4-30
1 – Locking Washer Tang
2 – Ridge
6. Turn the pivot bolts all the way in by hand.
Ensure that the steering assembly pivots freely.
7. Torque the pivot bolts.
UREA Grease Water Resistant Type NLGI #2
Where Used Part Number
Power Steering Bushings Obtain Locally
(1)
0006067
(1) (2)
000606 8
UREA Grease Water Resistant Type NLGI #2
Where Used Part Number
Upper and Lower Pivot Bolts Obtain Locally
Upper and Lower Pivot Bolt Torque
N·m lb-ft
35 26
(1)
(2)
0006069