Yanmar ViO12-2A, Service Manual

Page: 216 / 409

6.
HYDRAULIC SYSTEM
6-7-5
Procedure
+DQGOHUHSODFHPHQW
Clamp the threaded section of the bent lever in a vice fitting
with V-shaped vice clamps.
Remove the pin (5 mm pin driver)
Remove : - pin,
- bent lever,
- handle.
Replace the bent lever onto the new handle and secure it with
the pin (5 mm pin driver)
1RWH
5HVSHFWWKHSRVLWLRQRIWKHEHQWOHYHUWRHQVXUHWKDWWKHKDQ
GOHLVFRUUHFWO\RULHQWHGDVLQGLFDWHGE\WKHPDFKLQHVWHFKQL
FDOVSHFLILFDWLRQV
Replace the nut on the threaded section and replace the boot.
Screw the handle onto the pilot control unit and tighten the nut
(19 mm open-end wrench).
Connect the new handle's electrical wiring to the machine's
electric system.
Fit the grommet into its emplacement while leaving enough
cable length so as to enable the correct handle operation.
Secure the cable to the grommet with a cable clamp.
Fold down the boot.