32
4. Operating procedure
Program operation
PROGRAM mode is to run programmed cycle such as figure below.
Setting the program operation
1 Turning on the controller
Turn the ELB on the right side of the main unit[ON(
｜
)].
Pressing the
key longer will turn the controller
power on.
The Top screen shows the temperature in the chamber
while the Bottom screen shows the set temperature.
The fan motor will start.
The fan motor operates when the door is open and stops
when the door is opened.
＊
Register target program prior to start running cycle at first.
For how to register a program, see “P.34 Programming method”.
Create as many as steps up to 99 at maximum and save programmed pattern data up to 99 in total.
(For example:11 program patterns will be stored at maximum, if each pattern is programmed 9
steps. The number of steps in the repeat interval will be the number of the steps set in the
registration part irrespective of the number of repetitions.
）
2 Select program mode
Press
key to turn PROGRAM Lamp on.
The bottom screen shows [
PGM
:
01]
([
01]
indicates a
program you used in the last session.)
※
Fixed Temperature mode would be selected at first
time operation. After that, the latest operated mode is
selected.
Target temp.
Setting time
Start programmed cycle
End programmed
cycle
Repeat
Repeat
