Yamaha YZF-R1P 2001-2003, Service Manual

Page: 89 / 439

2 - 39
SPEC
CABLE ROUTING
Pass the filter of throttle body
through the hole of rubber
baffle and release it under
the ignition coil plate.
Route the sub lead coupler
behind the ignition coil.
Pass the camshaft position
sensor lead through the hole
of COVER 1 and connect it.
After branching the harness,
clamp each lead of the (+)
lead junction, starting circuit
cut-off relay, atmosphere
pressure sensor, lean angle
cut-off switch flasher relay in
the lump. Do not clamp the
ALARM coupler lead. Press the lead of the coupler
for ALARM in under the cou-
pler of ECU.
Pay attention not to allow the
lead to slack and get caught
after wiring when assembling
the side cover.
Make sure to hook the har-
ness on the hook of battery
box.
Pick-up coil lead
(Should be wired in front of
the clamp.)
Neutral switch lead
(Should be wired in front of
the clamp.) Fasten the (+) lead junction
lead by hooking on the pawl
of the box battery.
Push the (–) lead coupler
into the down side of wire
harness clamp.
Pull in the lead to the posi-
tion inside the frame until the
different color tape attached
to the lead is invisible out-
side the frame bottom edge. A K
A L
A M
A N
A O
A P
A Q
A R
A S
A T
A U
A V