Yamaha YDRE, Owner'S/Operator'S Manual

Page: 22 / 208

1
2
3
4
5
6
7
8
9
10
11
CONTROLS
4-5
JC1
TOW SWITCH
Before operating the car, make
sure the tow switch is in the “RUN”
position.
å
Tow switch
Ensure that the “Drive Select
Switch” is in the “FWD” position
and then move the “TOW Switch”
to “TOW” before towing.
After moving switch from “RUN”
to “TOW,” wait 15 seconds
minimum before switching again.
Failure to do so may lead to drive
system damage while towing.
HEADLIGHT/TAILLIGHT
ON POSITION
Turn the main switch all the way to
the right to the second ON position.
This will activate the headlights and
taillights.
HORN SWITCH
The horn is located adjacent to the
brake pedal, and is activated by
depressing with your foot.
∫
Horn Switch
TIP
It is advisable to sound the horn
when approaching blind corners.
NOTICE
REV F W D
Y-22 7 2
OFF ON ON
DEATH OR SEVERE PERSONAL INJURY CAN RESULT FROM FAILURE TO FOLLO W THESE INSTRUCTIONS.
• Read the label located on the steering wheel before operation.
• Operate only when authori z ed and only in designated areas.
• Operate from driver’s side only.
• Do not allow more than two occupants per seat.
• Do not start vehicle until all occupants are seated.
• Remain seated and hold on when in motion.
• K eep entire body inside vehicle.
• Drive slowly in turns.
• Drive slowly straight up and down slopes.
• Set parking brake before leaving vehicle.
• Turn main switch to “ OFF ” and remove key when not in use.
• Do not operate while under the influence of alcohol or drugs.
YAMAHA
W ARNIN G
JC1 - K77 68- 00
0 1
-
Y-9 01 B
B
Y- 1 99 5
TO
W
RU
N
A
JC1_F8199_70_ENG.qxp_LIT_19626_00_81.qxd 10/17/14 4:12 PM Page 17