Yamaha XVS650H 2016, Owner'S Manual, Page: 80 / 96

Perio d ic maintenance an d a d justment
7-38
7
2. Install the final gear case bolts.
3. Install the brake rod onto the
brake camshaft lever, and then in-
stall the brake pedal free play ad-
justing nut onto the brake rod.
4. Install the brake torque rod bolt
and nut at the brake shoe plate.
5. Install the panel.
6. Lower the rear wheel so that it is
on the ground, and then put the
sidestand down.
7. Tighten the axle nut, the final gear
case bolts and the brake torque
rod nuts to the specified torques.
8. Adjust the brake pedal free play.
(See page 7-22.)
WARNING
EWA10661
After a d justin g the b rake pe d al free
play, check the operation of the
b rake li g ht.
EAU25852
Trou b leshootin g
Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
for example, can cause poor starting
and loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
WARNING
EWA15142
When checkin g the fuel system, d o
not smoke, an d make sure there are
no open flames or sparks in the ar-
ea, inclu
d in g pilot li g hts from water
1. Middle gear universal joint
2. Drive shaft
Ti g htenin g torques:
Axle nut:
92 N·m (9.2 kgf·m, 67 lb·ft)
Final gear case bolt:
74 N·m (7.4 kgf·m, 54 lb·ft)
Brake torque rod nut:
20 N·m (2.0 kgf·m, 14 lb·ft)
U1BF27E0.book Page 38 Tuesday, May 17, 2016 8:35 AM