Yamaha XS650 Series, Shop Manual

Page: 137 / 215

Part to be tightened
Brake disc and hub
Caliper and support bracket
Caliper and pad
Caliper and bleed screw
Front caliper and front fork
Master cylinder and cylinder bracket
Pivot shaft
Rear wheel axle
Tension bar and brake caliper (plate)
Tension bar and rear arm
Thread dia. and part name Tightening torque
8 mm bolt 2.0 m-kg (14.5 ft-lb)
8 mm bolt 1.8 m-kg (13.0 ft-lb)
5 mm bolt 0.3 m-kg 2.2 ft-lb)
8 mm bolt 0.6 m-kg 4.5 ft-lb)
10 mm bolt 3.5 m-kg (25.5 ft-lb)
6 mm bolt 0.6 m-kg 4.5 ft-lb)
14 mm nut 6.5 m-kg (47.0 ft-lb)
16 mm nut 15.0 m-kg (108.5 ft-lb)
8 mm nut 1.8 m-kg (13.0 ft-lb)
8 mm nut 3.2 m-kg (23.0 ft-lb)
Rear shock absorber Upper 10 mm bolt
Rear shock absorber Lower 10 mm bolt
Rear arm and rear arm end 8 mm bolt
Front fender 8 mm bolt
Neutral switch 12mm
3.0 m-kg (21.5 ft-lb)
3.9 m-kg (28.0 ft-lb)
1.0 (7.2 ft-lb)
1.0 m-kg 7.2 ft-lb)
1.3 m-kg 9.5 ft-lb)
General Torque Specifications tighten multi-fastener assemblies in a criss-
This chart specifies torque for standard cross fashion, in progressive stages, until full
fasteners with standard I.S.O. pitch threads. torque is reached. Unless otherwise specified,
Torque specifications for special components torque specifications call for clean, dry
or assemblies are included in the applicable threads. Components should be at room
sections of this book. To avoid warpage, temperature.
A
(Nut)
IOmm
1 2 m m
14 mm
1 7 m m
B
(Bolt)
6 m m
8 m m
10mm
1 2 m m
Standard tightening torque
m-kg ft-lb
0.6 4.5
1.5 11
3.0 22
5.5 4 0
19mm
14 mm 8.5 61
22 mm 1 6 m m 13.0 94
- 2 4 -