2-24
Diagnosis function
ELEC
–
+
2) Motor current
a. “14” is displayed in the diagnosis mode dis-
play
1
of the display unit.
b. Press the function select switch “
s
” of the
display unit.
c. The diagnosis data display
2
of the display
unit displays the motor output current (%)
from “0” to “100”.
d. Confirm that the diagnosis data display
2
of
the display unit displays “100” when apply ing
the rear brake and strongly pressing on the
pedals.
• “100” is displayed: good
• “100” is not displayed: If the bicycle was
ridden immediately before checking the
motor current, it is possible that the bat tery
or the controller temperature control is
working; therefore, wait until the bicycle
cools down. If the bicycle was not ridden
immediately before checking the motor
current, recheck using a battery that is op-
erating properly.
• “100” is not displayed: The battery re-
sponse is weak in winter (low tempera-
tures), so use a battery that has been
stored in a heated room.
• “100” is not displayed: Replace the con-
troller assembly.
e. Press the light switch “
” of the display unit.
f. Proceed to 3) Error displays.
