Yamaha VP1, Owner'S Manual

Page: 104 / 174

REFERENCE
Chapter 1 PLAY Mode 1 - 35
Editing Functions
VOICE SETUP: Zoned Aftertouch Mode
PLAY
➝
F6
: VSet
➝
Move cursor to ZneATMode.
Sets the aftertouch mode for each element.
ZneATMode 0: all, 1: top, 2: bottom
3: mid, 4: spl_hi
5: spl_lo
Description
• Use this setting to select the way the VP1 applies received aftertouch data.
Available selections are as follows.
• 0: all
Aftertouch effect applies to all notes.
• 1: top
Aftertouch effect applies to the highest note only.
• 2: bottom
Aftertouch effect applies to the lowest note only.
• 3: mid
Aftertouch effect applies to all except the lowest and highest notes. No effect is
applied unless at least three notes are being played.
• 4: spl_hi
Aftertouch effect applies only at or above the split-point. (See next page.)
• 5: spl_lo
Aftertouch effect applies only at or below the split-point. (See next page.)
• The window at the right of the screen indicates the current setting for each element.
Elements that are “off” are indicated as “------”.
Important
• Aftertouch data from the keyboard is output as channel pressure.
• If you select spl_lo or spl_hi (setting 4 or 5), you must also select the split-point.
For details, refer to the next page.
• You cannot make this setting for an element whose Element Switch is “off”. (
➝
REFERENCE: 1-17)
FYI
• You can use the 1 ~ 4 buttons to switch among elements, and the 9 ~
12 buttons to toggle elements on and off during editing.