Yamaha Tyros4, Service Manual

Page: 26 / 173

Tyros4
26
3
Remove the four screws from the cover.
NOTE:
Keep the removed screws in a safe place. They will be used
when reattaching the cover to the instrument after installation.
4
Insert the module into the socket by following
the procedure below.
4-1
Insert the module vertically in the socket and
position the screws (of the module) to the female
screws respectively.
4-2
Press the top of the connector as shown, then push
the connector fi rmly into the socket.
4-3
Tighten each screw of the module to each female
screw of the Tyros4 with your hand as shown.
(Rear side)
Flash Memory
Expansion Module
Connector
Female screw
Socket
Female screw
(Rear side)
5
Re-install the cover you removed in step 3, in
reverse order.
6
Check that the installed module is functioning
properly.
6-1
Set the Tyros4 right-side up, and then turn the
power on.
6-2
Call up the Format operation display.
[VOICE CREATOR]
g
[E] EXPANSION
MODULE
6-3
Execute the Format operation following the
messages on the display.
If the module has been installed properly, the appropriate
available memory size is indicated in the PROPERTY
display.
([VOICE CREATOR]
g
[E] EXPANSION MODULE
g
[7
q
] − [8
q
] PROPERTY)
4-3
4-2