Yamaha TT600R, Service Manual

Page: 71 / 380

INSP
ADJ
3-19
ENGINE OIL REPLACEMENT
7
6
Engine oil replacement (with oil filter replace-
ment)
1. Warm up the engine for a few minutes.
2. Stop the engine. Place an oil pan under the
engine and remove the oil filler cap.
3. Remove the drain plug (1) and drain the
engine oil.
4. Remove two bolts (2) and O-ring of the oil
hose flange, and drain the oil from oil tank.
5. Remove the air bleed screw (3) attached to
the oil filter cover (4).
6. Wait until the oil has completely drained.
NOTE:
The oil filter cover is secured by three screws (5).
The lower one should be removed so that the fil-
ter cavity will drain.
5
3
4
7. Remove the other filter cover screws and
remove the oil filter cover.
8. Remove the oil filter (6) and O-ring (7).
9. Inspect:
•
All gaskets
•
O-rings
Damaged
➔
Replace.
10. Reassemble:
•
(New) filter cartridge
•
Filter cover screw
•
Oil filter cover bleeder screw
•
Engine drain plug
•
Oil tank hose
Fastening torques:
Drain plug (engine):
30 Nm (3.0 mkg)
Oil tank hose (flange):
10 Nm (1.0 mkg)
Filter cover screw:
10 Nm (1.0 mkg)
Oil filter cover bleeder screw:
5 Nm (0.5 mkg)