PERIODIC MAINTENANCE AND ADJUSTMENT
7
7 - 2 5
3. Push the ignition switch to set it to
“ON”.
4. If the fuse immediately blows
again, have a Yamaha dealer check
the electrical system.
EAU24350
Supporting the motorcycle
Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear wheel
or performing other maintenance requir-
ing the motorcycle to stand upright.
Check that the motorcycle is in a stable
and level position before starting any
maintenance. A strong wooden box can
be placed under the engine for added
stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack
under the frame in front of the rear
wheel.
2. Raise the front wheel off the ground
by using a motorcycle stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
EAU24360
Front wheel
EAUW0541
To remove the front wheel
EWA10821
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Lift the front wheel off the ground
according to the procedure on
page 7-25.
1. Axle nut
3. Remove the axle nut and washer.
4. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
not apply the brake after the
wheel has been removed to-
gether with the brake disc, oth-
Cap_7-15.pmd
3/2/2009, 09:27
25
Summary of Contents for TT-R230Y
Page 9: ...LOCATION OF IMPORTANT LABELS 1 1 2 Cap_1 15 pmd 29 1 2009 10 21 2 ...
Page 27: ...FORYOUR SAFETY PRE OPERATION CHECKS 5 5 2 Cap_5 15 pmd 2008 06 04 07 59 2 ...
Page 34: ...7 4 PERIODIC MAINTENANCE AND ADJUSTMENT 7 Cap_7 15 pmd 3 2 2009 09 27 4 ...
Page 69: ...CONSUMER INFORMATION 10 10 5 Cap_10 15 pmd 29 1 2009 12 18 5 ...
