6 - 1
OPERATION AND IMPORTANT RIDING POINTS
6
EAU15951
Read the Owner’s Manual carefully to
become familiar with all controls. If there
is a control or function you do not
understand, ask your Yamaha dealer.
EWA10271
Failure to familiarize yourself with the
controls can lead to loss of control,
which could cause an accident or
injury.
EAUW0592
Starting and warming up a
cold engine
In order for the starting circuit cut-off
system to enable starting, one of the
following conditions must be met:
z
The transmission is in the neutral
position.
z
The transmission is in gear with the
clutch lever pulled.
See page 4-8 for more information.
1. Turn the fuel cock lever to “ON”.
2. Push the ignition switch to set it to
“ON”.
3. Shift the transmission into the
neutral position.
4. Turn the starter (choke) on and
completely close the throttle. (See
page 4-6.)
5. Start the engine by pushing the
start switch.
If the engine fails to start, release
the star t switch, wait a few
seconds, and then try again. Each
starting attempt should be as short
as possible to preserve the battery.
Do not crank the engine more than
10 seconds on any one attempt.
6. After starting the engine, move the
starter (choke) back halfway.
NOTICE: For maximum engine
life, always warm the engine up
before starting off. Never accel-
erate hard when the engine is
cold!
[ECA11131]
7. When the engine is warm, turn the
starter (choke) off.
TIP
The engine is warm when it responds
normally to the throttle with the starter
(choke) turned off.
Cap_6-15.pmd
29/1/2009, 11:30
1
Summary of Contents for TT-R230Y
Page 9: ...LOCATION OF IMPORTANT LABELS 1 1 2 Cap_1 15 pmd 29 1 2009 10 21 2 ...
Page 27: ...FORYOUR SAFETY PRE OPERATION CHECKS 5 5 2 Cap_5 15 pmd 2008 06 04 07 59 2 ...
Page 34: ...7 4 PERIODIC MAINTENANCE AND ADJUSTMENT 7 Cap_7 15 pmd 3 2 2009 09 27 4 ...
Page 69: ...CONSUMER INFORMATION 10 10 5 Cap_10 15 pmd 29 1 2009 12 18 5 ...
