Yamaha Tracer MT09TRAH 2017, Service Manual

Page: 91 / 574

CABLE ROUTING
2-50
1. Clamp
2. Rear brake light switch lead
3. O
2
sensor coupler
4. Radiator fan motor coupler
5. Handlebar switch coupler (right)
6. Inner panel
7. Front right turn signal light coupler
8. Fuse box 1
9. Front turn signal light lead (right)
10.Bracket
11.Fuse box 2
12.Coupler cover
13.O
2
sensor lead
14.Frame
15.Engine
A. Insert the clamp into the long hole in the bat-
tery box.
B. Route the rear brake light switch lead outside
the wire harness branch to the O
2
sensor
lead.
C. To the ECU coupler
D. Connect the O
2
sensor coupler, and then fas-
ten to the bracket. Make sure that the top of
the coupler does not protrude. It is okay if the
cover is deformed.
E. Fasten the O
2
sensor lead with the clamp,
and then install it on the bracket.
F. Route the O
2
sensor lead and the rear brake
light switch lead through the bracket guide.
G. Route the rear brake light switch lead outside
brake fluid reservoir hose.
H. It does not matter whether the O
2
sensor lead
or the rear brake light switch lead is on top
(bottom) in the area shown in the illustration.
I. Connect the radiator fan motor coupler and
then position it in front of the connector cover.
J. Insert the handlebar switch coupler (right)
into the bracket.
K. Insert the clamp of the handlebar switch lead
(right) into the hole in the bracket.
L. Insert the front right turn signal light coupler
into the inner panel.
M. Insert fuse box 1 into the bracket.
N. Route the front turn signal light lead (right)
under fuse box 1.
O. Insert fuse box 2 into the bracket.
P. Insert the clamp so that it touches the rim of
the frame.
Q. Fasten the O
2
sensor lead with the holder.
R. Route O
2
sensor lead inside to the protrusion
of the bracket.
S. Inside vehicle