Yamaha Tracer MT09TRAH 2017, Service Manual

Page: 93 / 574

CABLE ROUTING
2-52
1. Guide
2. Wire harness
3. Pipe (headlight stay)
4. Clamp
5. Frame
6. Auxiliary DC jack coupler (color: natural)
7. Auxiliary DC jack coupler (color: black)
8. Auxiliary DC jack lead
9. Auxiliary light lead
10.Coupler cover
11.Auxiliary light coupler
12.Throttle cable
13.Wire harness protector
14.Main switch coupler
15.Immobilizer coupler
16.Front wheel sensor coupler
17.Main switch lead
18.Main switch coupler 1
19.Main switch coupler 2
20.Sponge
21.Sponge edge
A. Bring the wire harness into contact with the
pipe (headlight stay), fasten them with the
clamp and then insert the clamp into the hole
in the headlight stay.
Make sure that the end of the clamp faces
forward when inserting it into the hole in the
headlight stay. It is not necessary to insert the
end of the clamp further into the hole oppo-
site to the hole in which it has been inserted.
B. Connect the coupler to the headlight unit.
C. Insert the clamp of the wire harness into the
hole in the headlight stay.
D. Fasten the main switch lead, immobilizer lead
and handlebar switch leads with the clamp.
Make sure that the main switch lead and
immobilizer lead are positioned backward
and the handlebar switch leads positioned
forward. Then, insert the clamp into the hole
in the headlight stay.
Align the clamp with the tapes (red to the left
and blue to the right) on the handlebar switch
lead and face the end of the clamp forward.
E. Make sure that there is no slack in the main
switch lead and immobilizer lead between the
clamps shown.
F. Make sure that the main switch lead, immobi-
lizer lead and handlebar switch leads are not
twisted between the clamps shown.
G. Fasten the wire harness, main switch lead,
and immobilizer lead with the clamp.
The wire harness, main switch lead, and
immobilizer lead should be fastened with the
clamp at the white tape.
Point the tip of the clamp outward, and then
cut it.
H. Connect the auxiliary DC jack to the auxiliary
DC jack coupler (color: natural) on the wire
harness.
I. Fasten the auxiliary light lead and auxiliary
DC jack lead with the clamp and then insert
the clamp into the hole in the headlight stay.
J. Fasten the main switch lead to the coupler
cover with the clamp.
K. The positions for the leads on the immobilizer
unit side do not matter regarding the main
switch lead.
L. Route the front wheel sensor lead rear side of
the vehicle respect to the main switch lead.
M. Install the clamp to the hole in the bottom of
the coupler cover.
N. Make sure that the main switch coupler does
not protrude from the sponge edge.
O. Align the wire harness protector with the
edge of the Velcro tape and wrap it. However,
the tape surface may protrude somewhat.