Yamaha Tracer MT09TRAH 2017, Service Manual

Page: 425 / 574

FUEL INJECTION SYSTEM
8-54
Fault code No. P0132
6 Defective throttle position sen-
sor.
Check throttle position sensor
signal 1.
Execute the diagnostic mode.
(Code No. 01)
When the throttle valves are
fully closed:
A value of 11–21 is indicated.
When throttle valves are fully
open:
A value of 96–106 is indicated.
Check throttle position sensor
signal 2.
Execute the diagnostic mode.
(Code No. 13)
When the throttle valves are
fully closed:
A value of 9–23 is indicated.
When the throttle valves are
fully open:
A value of 94–108 is indicated.
An indicated value is out of the
specified range

Replace the
throttle position sensor.
Turn the main switch to “ON”,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha
diagnostic tool.
Condition is “Recovered”

Go
to item 8 and finish the service.
Condition is “Detected”

Go to
item 7.
7 Malfunction in ECU. Replace the ECU.
Refer to “REPLACING THE
ECU (Engine Control Unit)” on
page 8-157.
Service is finished.
8 Delete the fault code and check
that the engine trouble warning
light goes off.
Confirm that the fault code has
a condition of “Recovered”
using the Yamaha diagnostic
tool, and then delete the fault
code.
Fault code No. P0132
Item
O
2
sensor: short circuit detected (power short circuit).
Fail-safe system
Able to start engine
Able to drive vehicle
Diagnostic code No. —
Tool display —
Procedure —
Item
Probable cause of malfunc-
tion and check
Maintenance job
Confirmation of service com-
pletion
Fault code No. P0122, P0123, P0222, P0223, P2135
Item
[P0122] Throttle position sensor: ground short circuit detected.
[P0123] Throttle position sensor: open or power short circuit
detected.
[P0222] Throttle position sensor: ground short circuit detected.
[P0223] Throttle position sensor: open or power short circuit
detected.
[P2135] Throttle position sensor: output voltage deviation error.