Yamaha SY99, Owner'S Manual

Page: 273 / 344

UTILITY MODE
Card utility
JUMP #812
Summary: Card utility jobs allow you to transfer
data to and from a card, and to format a card to
accept SY99 data.
Procedure:
From: System utility
MIDI utility
Disk utility
Sample utility
MDR utility
Master control
Press: F3 (Card)
Select: the desired card utility job and press
ENTER.
(JUMP #800)
(JUMP #806)
(JUMP #816)
(JUMP #826)
(JUMP #830)
(JUMP #831)
(JUMP #812)
Move the cursor in this area to Select one of the
following jobs and then press ENTER.
01: Load From Data Card: Synthesizer data can
be loaded from a DATA card (RAM card or
ROM card).
02: Save To Data Card: Synthesizer data can be
saved to a RAM DATA card.
03: Format Data Card: Before you use a new
MCD64 RAM card, you must use this oper-
ation to format it.
04: Load From Wave Card: Waveform data can
be loaded from a WAVEFORM card.
To move to a different utility mode press F1-F2
or F4-F7. To select a job from the currently dis-
played job directory, hold SHIFT and press a
function key.
CARD UTILITY
1. Load from data card
JUMP #814
Summary: Synthesizer data can be loaded from a
RAM or ROM card.
Procedure:
From: card utility job directory (JUMP #812)
Select: 01:Load From Data Card (JUMP #814)
Specify: the type of data to be loaded.
To execute: the load operation press F8 (Go).
To quit: without executing press EXIT.
Data Type (synth all, multi&voice (pan, met),
synth setup): You can load all or part of the data
from card. When "synth all" is selected all the
data will be loaded. When "multi&voice (pan,
met)" is selected multi, voice, pan, and micro-
tuning data will be loaded. When "synth setup"
is selected the system setup data will be loaded.
If the card was formatted for the SY77,
"synth all" will be the only choice.
This function loads the specified type of synthesizer
data from a RAM or ROM card inserted in the DATA
card slot. After selecting the data type to load,
press F8 (Go) to load the data from card. The dis-
play will ask "Are you sure?" so if you are sure you
want to load the data press YES.
If the card inserted in the DATA slot is formatted
for a different type of device the LCD will show
"ERROR: Illegal Format!" Press EXIT to exit from
the error message.
System setup data: The system setup data loaded
when "synth all" or "synth setup" data is
selected consists of all System utility, MIDI
utility, and master control settings. The MDR/
sample memory allocation ratio or master
controller select will be changed as a result of
either of these load operations.
262