VOICE EDIT MODE
AModSens and PModSens: These settings deter-
mine the sensitivity of each operator to the Ampli-
tude Modulation Depth (AMD) and/or Pitch Modu-
lation Depth (PMD) produced by the LFO. Refer to
6.(F1) AFM LFO (Main) (JUMP #244). If the LFO
settings for AMD and/or PMD are set to 0, these
AModSens and PModSens settings will have no
effect.
PModSens determines the sensitivity of each
operator to PMD from the Main LFO.
Independently of this, the pitch of an AFM element
can also be affected by the Sub LFO. Refer to
6. (F2) AFM LFO (Sub) (JUMP #245).
In this AFM sensitivity display, the OPERATOR
SELECT buttons cannot be used to select operators.
AFM ELEMENT DATA
6.(F1) AFM LFO (Main)
JUMP #244
Summary: The Main LFO creates a periodic control
signal that can be used to create tremolo (ampli-
tude modulation), vibrato (pitch modulation),
and wah-wah (filter modulation).
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 06:LFO and press (JUMP #244)
Fl (Main)
Specify: parameters for the main LFO
Wave (triangle, saw down, saw up, square,
sine, sample&hold): This selects the wave
(shape of modulation) produced by the Main
LFO. The selected wave is graphically displayed
in the LCD. When sample&hold is selected, the
LFO will produce a control signal whose level
will change randomly at intervals of time deter-
mined by the Speed setting.
Speed (0...99): The speed of the LFO modula-
tion. Higher settings result in faster modulation.
At a setting of 0, one cycle will be approximately
34 seconds.
Delay (0...99): The time delay before the LFO
modulation begins.
Init Phase (0...99): Initial Phase determines the
point of the waveform from which the LFO will
begin when a key is pressed. The LFO wave-
form always starts over again from this initial
phase point when each note is played. An initial
phase setting of 0...99 corresponds to a phase of
0...360 degrees.
A Mod Depth (0...127): Amplitude Modulation
Depth determines how much the LFO will affect
the output level (amplitude) of the operators.
For this setting to have an effect, the
AModSens (amplitude modulation sensitivity)
of an operator must be set above 0. Refer to 5.
AFM sensitivity.
146
Summary of Contents for SY99
