Initialization
32
SWR2311P-10G Owner’s Manual
■
Using the cold start command to restore the factory settings
You can return the unit to its factory settings by using a command line setting via the CON-
SOLE port, Telnet, or an SSH client.
Here we assume that you are logged in as described in “Logging in from a computer con-
nected to the CONSOLE port” (page 27).
1.
Enter enable, and press the <Enter> key.
You are now in privileged EXEC mode.
2.
Enter the cold start command, and press the <Enter> key.
You will be asked to enter the administrative password.
If a password has already been specified, enter the password.
When the unit is shipped from the factory, a password has not been specified, so it need not
be entered.
3.
Press the <Enter> key.
The unit returns to the factory-set state, and then restarts.
■
Entering the <I> (uppercase I) key during startup to restore the factory
settings
The unit can be restored to its factory settings by entering an uppercase <I> when the unit is
starting up. This explanation uses the method of disconnecting and reconnecting the power
cord. The procedure is also the same when using the reload command to restart this unit.
Notice
Here we assume that you are logged in as described in “Logging in from a computer connected to
the CONSOLE port” (page 27).
1.
Disconnect and then reconnect the power cord of this unit.
2.
During restart, enter an uppercase <I> within one second after the BootROM
Ver (see below) appears on the console screen.
3.
When a screen asks you whether to execute initialization, press the <y> key
to execute initialization.
Initialization is executed.
SWR2311P>enable
SWR2311P#
SWR2311P#cold start
Password:
SWR2311P BootROM Ver.1.00
Initialize or not ?(y/n)
Ready to Initialize
...............
