Settings
26
SWR2311P-10G Owner’s Manual
Here we explain the cable, driver, software, and settings that are necessary in order to use the
CONSOLE port.
If the date and time are incorrect, set the date and time either in “clock set” command / “clock
timezone” command.
For details on the commands used by this unit, refer to the Command Reference.
The Command Reference is available on the Yamaha Pro Audio website.
http://www.yamaha.com/proaudio/
■
Preparing a console cable
• Connect the computer to the CONSOLE port of this unit using a USB cable or an
RJ-45/DB-9 console cable.
• As the USB cable connected to the mini-USB CONSOLE port, use a USB cable that
is equipped with a USB Type A connector and a mini-USB Type B (5-pin) connector,
and that supports data communication. Charge-only cables cannot be used.
■
Installing the USB serial driver
• In order to use the mini-USB CONSOLE port, the USB serial driver must first be
installed in the computer.
• For details on installing the USB serial driver, refer to the “Yamaha Network USB
Serial Driver Installation Guide.”
The Yamaha Network USB Serial Driver Installation Guide and the installer can be down-
loaded from the Yamaha Pro Audio website.
http://www.yamaha.com/proaudio/
■
Preparing the computer
You will need terminal software that controls the serial (COM) port of the computer.
Set the parameters of the terminal software as follows.
If the computer is connected to both the RJ-45 CONSOLE port and the mini-USB CON-
SOLE port, only the terminal software that uses the mini-USB CONSOLE port can make
settings.
The messages that are output from this unit are output to both CONSOLE ports.
Making settings from the command line using the
CONSOLE port
Parameter
Value
Data transmission speed
9600 bps
Character bit length
8
Parity check
None
Number of stop bits
1
Flow control
Xon/Xoff
