INSTRUMENT AND CONTROL FUNCTIONS
4-8
4
Right
EAU12400
Dimmer switch “
/
”
Set this switch to “
” for the high
beam and to “
” for the low beam.
EAU12430
Turn signal switch “
/
”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “
”. When re-
leased, the switch returns to the center
position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the vehicle
has traveled both about 150 m (490 ft)
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the cen-
ter position.
TIP
The self-canceling system only oper-
ates when the vehicle is moving, so that
the turn signal lights will not self-cancel
while you are stopped at an intersec-
tion.
EAU12500
Horn switch “
”
Press this switch to sound the horn.
EAU12660
Engine stop switch “
/
”
Set this switch to “
” before starting
the engine. Set this switch to “
” to
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU38331
Light switch (for optional
lights) “
”
This model can be equipped with op-
tional lights available at a Yamaha
dealer.
Push this switch to the left to turn the
optional lights on and to the right to turn
them off.
NOTICE
ECA15321
Do not install a bulb which exceeds
12 V, 35 W in either light, otherwise
the headlight fuse may blow or the
battery may discharge.
EAU12711
Start switch “
”
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
EAU41700
The engine trouble warning light will
come on when the key is turned to “ON”
and the start switch is pushed, but this
does not indicate a malfunction.
1. Engine stop switch “
/
”
2. Light switch (for optional lights) “
”
3. Start switch “
”
U1D713E0.book Page 8 Thursday, May 8, 2008 4:19 PM
