Yamaha S03 voice editor, Owner'S Manual

Page: 66 / 112

66
Multi Mode
19. AC1 CC No
(AC1 Control Change Number)
Determines the Control Change number for the AC1
(Assignable Controller 1) of each Part
❏
Settings : 0~95
n
The AC1 CC No parameter in the Voice mode is set in the
Utility mode (PAGE 7).
AC1 (Assignable Controller 1)
The AC1 (Assignable Controller 1) is only available
by using an external MIDI controller (such as a foot
controller connected to a MIDI keyboard). By
setting the AC1 Control Change number here to
match the controller on the connected MIDI device,
you can use that controller to change the sound,
according to the settings made in the other AC1
parameters — such as AC1FltCtl, AC1 FMod/PMod,
or the Variation Effect’s AC1VarCtl.
For example, by setting AC1 to “2” here, you can use
a breath controller to control the Voice of a Part.
If the connected MIDI controller is set to “0,” the
Part cannot be controlled, even by setting the proper
Control Change number. For best results, also make
sure that the sensitivity parameters (AC1FitCl, AC1
FMod/PMod, or the Variation Effect’s AC1VarCtl)
are set appropriately, as needed.
20. AC1FltCtl (AC1 Filter Control)
Set the amount by which the filter cutoff frequency
changes when the controller (Assignable Controller 1)
is used.
❏
Settings : –64~+63
21-1. AC1 FMod
(AC1 Filter Modulation Depth)
21-2. AC1 AMod
(AC1 Amplitude Modulation Depth)
These parameters let you set the depth of control the
Control Change messages (via Assignable Controller 1)
have over the filter and amplitude of the Part (Voice).
❏
Settings : 0~127
■
AC1 FMod
Set the amount by which the filter Cutoff frequency
changes when Assignable Controller 1 is used. The
larger the setting, the greater the depth of control.
(The wah effect becomes deeper.)
■
AC1 AMod
Set the depth of control that Assignable Controller 1
has over the amplitude modulation. A larger setting
means a larger modulation depth. (The tremolo
effect becomes deeper.)
n
Depending on the selected LFO wave type and the
amplitude modulation depth setting, noise may result
when the controller is moved. If this happens, reduce
the modulation depth value.
22. ReverbSend
Set the send level of the Reverb Effect.
❏
Settings : 0~127
n
In the value is too high, noise may result. If this happens,
reduce the value.
23. ChorusSend
Set the send level of the Chorus Effect.
❏
Settings : 0~127
AC1 CC No
00
KEY ELEM PART
OCTAVE
PAGE
19 P 1
AC1FltCtl
+00
KEY ELEM PART
OCTAVE
PAGE
20 P 1
AC1 FMod
000
KEY ELEM PART
OCTAVE
PAGE
21 P 1
AC1 AMod
000
KEY ELEM PART
OCTAVE
PAGE
21 P 1
ReverbSend
040
KEY ELEM PART
OCTAVE
PAGE
22 P 1
ChorusSend
000
KEY ELEM PART
OCTAVE
PAGE
23 P 1
Part Controller/Part Effect