PREPARATIONS
➤
Connecting speakers
En
16
Connect the speakers placed in your room to the unit.
The following diagrams provide connections for
5.1-channel system as examples. For other systems,
connect speakers while referring to the connection
diagram for the 5.1-channel system.
Cables required for connection
(commercially available)
Speaker cables (x the number of speakers)
Audio pin cable (x1: for connecting a subwoofer)
5.1-channel system
■
Connecting speaker cables
Speaker cables have two wires. One is for connecting
the negative (-) terminal of the unit and the speaker, and
the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to
the negative and the other wire to the positive terminal.
a
Remove approximately 10 mm (3/8”) of insulation from
the ends of the speaker cable and twist the bare wires of
the cable firmly together.
b
Loosen the speaker terminal.
c
Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
d
Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China, Australia and General models only)
a
Tighten the speaker terminal.
b
Insert a banana plug into the end of the terminal.
2
Connecting speakers
Caution
• Remove the unit’s power cable from an AC wall outlet and turn
off the subwoofer before connecting the speakers.
• Ensure that the core wires of the speaker cable do not touch
one another or come into contact with the unit’s metal parts.
Doing so may damage the unit or the speakers. If the speaker
cables short circuit, “Check SP Wires” will appear on the front
display when the unit is turned on.
–
+
–
+
SPEAKERS
CENTER
EXTRA SP
FRONT
DC OUT
COMPONENT
VIDEO
VIDEO
MONITOR
OUT
SUBWOOFER
PRE OUT
SURROUND / ZONE 2
/BI-AMP
5V
0.5A
Y
P
B
P
R
A
AM
FM
75
1
2
3
4
5
9
The unit (rear)
FRONT
-
+
a
a
b
d
c
+ (red)
- (black)
FRONT
+
a
b
Banana plug
1 2 3 4 5 6 7 8 9 10
RX-S600_S600D_om.book Page 16 Tuesday, May 28, 2013 1:36 PM