38
En
REMOTE CONTROL FEATURES
To use this unit’s remote control to control other
components (TV, DVD player, VCR, etc.), determine the
remote control code that corresponds to the component
and assign that code to the desired input selector button on
the remote control. Remote control codes are listed in the
“LIST OF REMOTE CONTROL CODES” at the end of
this manual.
■
Default remote control configuration
The remote control is configured at the factory as shown
below.
If you cannot operate a Yamaha component when the remote
control is configured using the remote control code listed above,
refer to the “LIST OF REMOTE CONTROL CODES” at the end
of this manual and try assigning a different Yamaha remote
control code.
■
Assigning remote control codes
1
Refer to the “LIST OF REMOTE CONTROL
CODES” at the end of this manual and
determine the remote control code that
corresponds to each of your components.
Components are listed by category (TV, VCR, DVD
player, etc.) and manufacturer.
2
Press and hold CODE SET on the remote
control for more than 3 seconds.
3
Press an input selector button on the remote
control to select the input source you want to
configure.
You can also press TV
A
to configure the TV control
buttons (see page 36).
4
Use the numeric buttons on the remote
control to enter the four-digit remote control
code corresponding to the component you
want to assign.
When the component has been assigned, “OK” is
displayed on the front panel display. If an error
occurs, “NG” is displayed.
• If the manufacturer of your component has more than one
remote control code, assign each code one at a time until you
find the code that successfully controls your component.
• You can only assign one remote control code to each input
selector button.
■
Resetting the remote control
Use this procedure to reset the remote control codes
assigned to each input selector to the factory default (see
“Default remote control configuration” above).
This procedure will be cancelled if you do not press any buttons
for 1 minute. If the procedure is cancelled, repeat from step 1 if
necessary.
1
Press and hold CODE SET on the remote
control for more than 3 seconds.
2
Press OPTION on the remote control.
3
Use the numeric buttons on the remote
control to enter “9981”.
The remote control code assigned to each input
selector button will be reset to its factory default
code.
Configuring the remote control
Button
Component
category
Manufacturer
Default
code
CD
CD player
Yamaha
5082
TAPE
TAPE deck
Yamaha
5087
PHONO
—
—
—
LINE 1
CD recorder
Yamaha
5083
LINE 2
DVD player
Yamaha
2082
LINE 3
Blu-ray disc
player
Yamaha
2064
TV
A
—
—
—
Note
Input selector
buttons
Numeric
buttons
CODE SET
OPTION
TV
A
Notes
Note
