Yamaha QR10, Owner'S Manual

Page: 31 / 61

25
1
Engage the REPEAT Function
Press the [REPEAT/SWING] key (the number
“9” key) while holding the [SHIFT] key.
2
Turn REPEAT ON or OFF
Use the [+1] key to turn the repeat function ON,
or the [–1] key to turn the repeat function OFF, as
required. When REPEAT is ON, an indicator block
will appear next to “REPEAT” on the display.
3
Exit
Press the [EXIT] key to exit when done.
■
Segment Repeat
To repeat playback of a specified segment of a song, start playback, press [REPEAT/SWING] while holding
[SHIFT] at the beginning of the segment you want to repeat (the REPEAT indicator block will flash slowly), then press
[REPEAT/SWING] while holding [SHIFT] again at the end of the segment you want to repeat (the REPEAT indicator
block will flash rapidly). The specified segment will continue to repeat until the segment repeat function is disengaged
by pressing [REPEAT/SWING] while holding [SHIFT] a third time (the REPEAT indicator block will disappear).
If you stop and then re-start playback without disengaging the segment repeat function, the song will initially play
through to the end of the repeat segment, then the segment will repeat continuously. Also note that the segment repeat
function is automatically cancelled if you select a different song or mode.
■
Tempo Settings, Track Muting, Voice Selection, and Pattern Selection in the
SONG Mode
Tempo settings, track muting, voice selection, and pattern selection all function the same way in the SONG mode as they
do in the PATTERN mode (selecting a different pattern changes the pattern used by the current song). With the preset songs,
however, these changes are temporary and will only remain in effect until a different song or mode is selected. Further, pattern
and voice changes made during preset song playback will be cancelled whenever a pre-programmed pattern or voice change is
encountered during playback.
■
Volume Settings in the SONG
Mode
Volume settings are made in the SONG mode in
basically the same way as the PATTERN mode
(page 21), except that the CHORD 1, CHORD 2,
BASS, and RHYTHM tracks can not be set inde-
pendently. You can only select and set the volume
for the MELODY track or the accompaniment
(“ACMP”) tracks as a group — CHORD 1, CHORD 2, BASS, and RHYTHM. Individual track volume levels must be set for
the corresponding pattern in the PATTERN mode.
6: Playing the Preset Songs (continued)