7
En
INSTALLATION
6
Pull the speaker cable out of the
hole which you have cut.
• Leave some extra length of cable when
pulling the cable out.
7
Connect the speaker cable to the
speaker.
• For detailed instructions, refer to page
9
“CONNECTING YOUR AMPLIFIER/
RECEIVER”
.
8
Place the speaker into the ceiling.
CAUTION
• When installing the speaker, do not
touch the drive unit directly. This may
cause a malfunction.
• Make sure that mounting clamps are
turned inward when installing the
speaker in a ceiling.
9
Insert the speaker into the hole.
Loosen three screws
approximately one turn counter-
clockwise. It will allow the clamps
to open easily.
Evenly tighten each of the three
mounting screws clockwise using a
Philips screwdriver. (At this time,
these three mounting clamps open
in the ceiling. These opened
clamps will press the ceiling board
and the speaker together to secure
the speaker.)
Loosen
NS-IC400.book 7 ページ ２０１０年１０月１９日 火曜日 午後２時５３分
