10
En
Eng
lish
CONNECTING YOUR AMPLIFIER/RECEIVER
• Lower the power amplifier/receiver volume control before changing input sources.
Never change input sources (for example, FM to CD) at high listening levels.
Always turn the receiver/amplifier unit off when installing or removing any cables.
• Anytime you note distortion, reduce the volume control on your power amplifier/
receiver to a lower setting. Never allow your power amplifier to be driven into
“clipping”.
The speaker grilles can be painted to match your room décor. Use high quality
spray paint and select a well ventilated area before proceeding.
*
S
pecifications subject to change without notice due to product improvements.
*
S
peaker cables are not included with this model.
After connecting
PAINTING THE
S
PEAKER GRILLE
1
Carefully remove the grille from the
speaker if attached.
2
Remove the scrim cloth that is
attached to the back of the grille.
(The adhesive that holds the cloth
in place is reusable.)
3
Apply the paint to the grille.
• Make sure that the grille holes remain
free of paint.
• Clogging the holes with paint may
diminish the sound quality.
4
When the paint has fully dried, re-
attach the scrim cloth to the back
of the grille.
5
Re-install the grille on the speaker.
S
PECIFICATION
S
N
S
-IC400
Type
Full range open back type
Driver
Full range
10 cm (4”) cone type
Frequency response
95 Hz to 40 kHz (-10dB)
Impedance
8 ohms
Nominal Input
30 W
Maximum input
90 W
S
ensitivity
85 dB / 2.83 V, 1 m
Dimensions (with grille)
φ
150
×
86.5D mm (
φ
5-7/8”
×
3-3/8”D)
Weight (with grille)
0.8 kg (1.76 lbs)
R A
NS-IC400.book 10 ページ ２０１０年１０月１９日 火曜日 午後２時５３分
