Error messages from YPAO
If any error message is displayed, resolve the problem by following on-screen instructions and perform YPAO
again.
[Search tag]#Q03 YPAO Error
Error message
Remedy
ERROR 1
Front speakers are not detected.
Exit YPAO, turn off the unit, and then check the speaker connections.
ERROR 2
One of the surround speakers
cannot be detected.
ERROR 3
One of the front presence
speakers cannot be detected.
ERROR 4
One of the surround back
speakers cannot be detected.
ERROR 5
The noise is too loud.
Keep the room quiet and retry YPAO. If you select “Proceed”, YPAO takes the
measurement again and ignores any noise detected.
ERROR 6
Surround back speakers are
connected, but no surround
speakers are connected.
Surround speakers need to be connected in order to use surround back
speakers. Exit YPAO, turn off the unit, and then reconnect the speakers.
ERROR 7
The YPAO microphone has been
removed.
Connect the YPAO microphone to the YPAO jack firmly and retry YPAO.
ERROR 8
The YPAO microphone cannot
detect test tones.
Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. If this
error occurs repeatedly, contact the nearest authorized Yamaha dealer or
service center.
ERROR 9
Canceled by user operation
Retry or exit YPAO as necessary.
ERROR 10
An internal error has occurred.
Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact
the nearest authorized Yamaha dealer or service center.
NOTE
(
To exit the YPAO measurement for resolving the problem, select “Quit”.
(
For the ERROR 5 and ERROR 9 messages only, you can proceed with the current YPAO measurement. Select “Proceed”.
(
To retry the YPAO measurement from beginning, select “Retry”.
108
PREPARATIONS > Configuring the speaker settings
Summary of Contents for MusicCast AVENTAGE RX-A4A
Page 1: ...AV Receiver User Guide EN ...